ADDER AdderLink X-DVIPRO-MS2 Guía de usuario descargar pdf (Pagina 6)

CONTENTSINTRODUCTIONINSTALLATIONOPERATION

FURTHER

INFORMATION

Installation

CONNECTIONS

Installation of the X-DVIPRO and X-DVIPRO-MS2 modules is straightforward and

requiresminimalcongurationinmostcases.

• Connections at the local module

• Connections at the remote module

Note: After all connections are made, power up the monitor and the REMOTE module rst

(followed by the LOCAL module, if using the X-DVIPRO-MS2 variant) and then switch on the

computer.

Mounting the modules – desk or rack

The X-DVIPRO and X-DVIPRO-MS2 modules can be situated on a desk or alternatively,

for larger installations, mounted within an optional rack mount chassis.

Desk mount

Apply the supplied self-adhesive rubber feet to

the underside of the module.

Rack mount

1 Place the rack securing plate (available as a separate kit) onto the front of the module

and secure it with the two countersunk screws.

2 Orient the X-DVIPRO (or X-DVIPRO-MS2) module on its side so that its labeled face

is the correct way up.

3 Slide the module into the required rack position. The rectangular cut-out in the front

upper lip of the rack allows the two screws on the module’s upper edge to slide

through.

4 Therackmountchassishasaseriesofholesinitsoorthatarespacedto

accommodate the two screws on the module’s lower edge. Ensure that the screws

correctly locate into the two holes of the chosen slot. The rack securing plate

onthemoduleshouldnowbeushwiththefrontoftherackmount

chassis.

5 Use the third (pan-head) screw, in the top hole of the rack

securing plate to fasten the module to the rack.

1 2 3 4 5 6 7 8 9 10 11 ... 15 16

Sin comentarios

ADDER AdderLink X-DVIPRO-MS2 Guía de usuario Pagina 6